9. 附录
9.1 错误运行状态下的程序
9.2 推荐润滑剂
尺寸图和位置图
推荐备件和易损件
9.1 错误运行状态下的程序
1. 辊子显示平行度错误。
- 所有的辊子必须在任何一个平面内互相平行（调整）。
2. 校正装置偏心。
- 采用拖板将校正装置向适当侧移动。
- 采用手动张紧装置对跑到一侧的毛毡进行校正。
- 采用毛毡张紧装置对毛毡进行适当校正。
- 采用手轮和适配器将活塞导承的中间位置调整最大12毫米。
华译网上海翻译公司曾经翻译过大量有关错误运行状态下的程序资料文件。
Beijing Chinese Subtitling Translation Service Agency has translated many technical documents about Procedure in the event of incorrect behavior.
9. Appendix
9.1 Procedure in the event of incorrect behavior
9.2 Recommended lubricant
Dimensional drawing and position drawing
Recommended spare parts and wear parts
9.1 Procedure in the event of incorrect behaviour
1. The rollers display parallelism errors.
-All rollers must be parallel to each other on every plane (adjust).
2. The correction device is off centre.
- Move the correction device to the appropriate side using the hand carriage.
-Correct the felt on one side with the manual tensioner.
-Correct the felt appropriately with the felt tensioner.
-Adjust centre position on the piston wide up to max. 12 mm with the hand wheel and adapter.
|
